Відео

Very good video , is there an expansion valve for the front of the cab AC?

Where can I get this iPad kit from

I can’t get the bar all the way through why?

Any part number of the pump?

What if they locked up mine just did that and smoking the drives

Hello! Are you changing the oil in an automatic transmission?

Mine is on the back of the truck, I guess it’s the same process.

Why release it back again after tightening it, sorry if it sounds stupidity ,new in trucking business ?

Replace dem pads

Do you recommend these LED lights?

Gracias.

这个工具不错

How much did the transmission fluid cost?

What was the spray you put so there's no corrosion?

What size impact wrench did you use 1/2 inch or 1 inch

Those are quarter fenders, not half fenders.

Are 3000 your inverted?

Just push the sleeper button in the front controls

It's called a sway bar link

Just ran across this in my feed. V6 car with a V8 front end?

520463

3323

Does a bad shock make truck lean to one side? I have a box truck, 2018 Freightliner M2 106

need update more

Thank you so much sir…I just changed my drivers side door handle!!! God Bless Brother!!!

Were your oem bulbs halogen or led?

Why I’m I seeing several fuel spots on the back of 2017 cascadia also on trailer front? Could the fuel vents pushing out fuel when driving? It’s been happening for a while now.

👍 Great im going to do mines know. AWESOME!!!

Is it good to do both sides when you have 1 of these to go bad on you. Or just the 1 that's bad.

Thank you

Are you from russia?

Hello When you turn on this mode, cold air blows whenever you set any temperature.

Thanks! What sizes are sockets for transmission filter and plugs? Where did you get that pump?

👍

dude those brake shoes will get you ouf of service.

You forgot to put lube on the o-ring and the rubber ring under the filter. Plus, do not tighten the filter with the tool ever. It will be really tough to take off next time. Generally for any screw-on filter, it is recommended to only use the tool to remove the filter and hands only to tighten it.

They've had those mounting brackets since the 90s. I've installed enuf after market car radios to know.

They have a install kit you buy to mount it in place. Guy. You didn't have to modify the outer covering.

so was it head gasket?

This video is pretty old but watching your video you already had freon in the system. Most times your expansion valves would be the first culprit to check, but without gauges on your ac lines your pissing in the wind trying to figure it out, but by the looks of the gauge on your charge can it wouldn't really let you add too much freon, first sign there's a blockage and those expansion valves close when there not functioning properly.. You have one for the front ac and one for the bunk ac...

What fender flares are you running?

What the link to purchase the fender liner?

Ignorant , that what you are because you already have fog lights but lets blind the incoming ,FY

fake it til ya make it

was wondering what this huge hole in my liner was for and i couldn't proceed because of it, watched this and seen how dumb i was for not knowing it was for the washer fluid. thanks im done

Did u apply the trailer brake or the pedal brake

Hey,be safe out there on the road!

Mines no longer reading any boost i thought it came pre adjusted

I just replaced same sensor in my truck, it’s showing me three - - - , any idea what could be the issue, ?

💥 I have to separate the brake line from the caliber and then bring the caliper somewhere to have the threads cleaned up because I stripped them ever so slightly. Could you tell me how to prevent the brake fluid from dripping out of the open line at the caliper end (the banjo bolt) in the half hour that I’ll be gone.??